PUNCH-IN RECORDING
Punching In means being able to 
automatically start recording right
in the middle of a track that is 
playing back, continue recording 
new data on that track for a 
specified number of measures, 
and then automatically stop 
recording at a specific measure 
and hear the rest of the track play
to the end.  This tool is very 
valuable if you wish to record 
over some misplayed notes in the 
middle of a track, but would like 
to preserve the music in the 
measures leading up to, and 
following, the trouble spot.

To use Punch-in recording:

1) Select Punch In/Out in the 
Advanced Recorder menu.

2) Use the L and R buttons to 
select the options and change their
values using the Dial.  Select 
AUTO with the R5 button to have 
the CP automatically handle the 
punching in/out while you play.

3) Press the REHEARSAL button 
(F4, F5) to listen to the song for 
rehearsal.  If you need to adjust 
mixing or if you would like to 
loop the song, use the MIXER 
(F2) or LOOP ON/OFF (F6) 
button.

4) When you are ready to record, 
press the REC button and then the 
PLAY button.  The music will 
start immediately from the Start 
Bar that you have chosen.  Once 
the song reaches the Punch In Bar, 
any notes that you play on the 
keyboard will be recorded.
Recording will stop when the 
song reaches the Punch-Out Bar, 
but the CP will keep playing back 
the song  to the end unless you 
press the STOP button.
You can repeat the punch-in/out 
section by turning the looping on 
with the F6 button.

5) Listen to what you have 
recorded and re-record if 
necessary. 

If you set the CP to Punch-In at 
the very first measure of the song,
the metronome will automatically 
play a two-measure intro to assist 
you with the timing.  These 
"ticks" will not be recorded as 
part of the track.

PUNCH-IN USING PEDAL
Instead of specifically setting an 
automatic Punch-In and Punch-
Out Bar, you can use the center 
pedal to manually Punch In and 
Out.

You can punch in and out with 
pedal one time for each pass over 
the track that you make.

To use the pedal to Punch-In/Out:

1) Use the R5 button to select 
Pedal in the Punch In/Out menu.

2) Use the L and R buttons to set 
up other recording options.

3) Press the REC button to start.  
The song will start playing.

4) When the song reaches the bar 
where you wish to punch in, press 
the pedal and play the keyboard.

5) When you reach the bar where 
you wish to punch out, press the 
pedal again to stop recording.  
Notice that the song keeps playing 
to the end (it's just no longer 
recording) or until you press 
STOP.

